Stainless Steel Ball Valves

>> Tuesday, March 03, 2009


I picked up some new ball valves off ebay. They're 1/2" Flowserve Series 4 all stainless steel ball valves and they are hefty. Each one weighs in at approximately 1.5 pounds and they're rated for up to 3000 PSI and 180 degrees Fahrenheit. I only paid $4.58 for both of them, pretty good deal. The 180 degree max temperature is a bit low so I won't be able to use them on my boil kettle, but they should work fine on the MT/LT, HLT, or conical fermenter.

Read more...

HERMS Design

>> Sunday, March 01, 2009

I'm in the process of building a HERMS system. The brains of the system is the BCS-460 Programmable Logic Controller from Embedded Control Concepts. It will be composed of the basic elements present in other HERMS systems:
  1. Hot Liquor Tank (HLT) - 5 gallon Rubbermaid cooler heated by a 1500 watt 120 volt water heater element
  2. Heat Exchanger (HX) - 2 gallon Rubbermaid Cooler heated by a 1500 watt 120 volt water heater element and consisting of 10 feet of 1/2" copper tubing
  3. Mash / Lauter Tun (MLT) - 10 gallon Rubbermaid cooler
  4. Pump - Brand a model to be determined
  5. Boil Kettle - 8 gallon
The controller will be used to turn the heating elements and pump on and off at various times throughout the brewing process.

Hot Liquor Tank >>


Read more...

HERMS Equipment - Hot Liquor Tank

The Hot Liquor Tank is based on a 5 gallon Rubbermaid cooler. The lid is drilled in the center and a temperature probe for the BCS-460 has been inserted. The HLT is heated by a 1500 watt 120 volt water heater element.

Heat Exchanger >>





Read more...

HERMS Equipment - Heat Exchanger

The Heat Exchanger is based on a 2 gallon Rubbermaid cooler. It holds approximately 1.5 gallons of water and is heated by a 1500 watt 120 volt water heater element. The heat exchange is accomplished with 10 feet of 1/2" copper tubing.

Mash Tun >>







Read more...

HERMS Equipment - Mash Tun

The Mash Tun is based on a 10 gallon Rubbermaid cooler. The lid is drilled and fitted with a grommet through which the return manifold is fitted. The return manifold is used for circulating the mash and for delivering the sparge water. It's contructed of 1/2" copper pipe and I've cut slots into the end of the T section in order to distribute the liquid without disturbing the grain bed.

1. System Startup >>


Read more...