Contents

Wednesday, March 18, 2009

Stir Plate - Step 1 - 2

I'm not going to go into a ton of detail because I figure most people that will attempt this project are somewhat technical and probably pretty handy. So here are the steps I used to build the stir plate:

1. I drilled a hole in the front of the project box for the rheostat. I also drilled a hole in the back for the power supply cord. Finally, I used a Dremel to cut out a relatively square-ish hole on the front for the power switch.


2. Next I connected the wiring...except for the fan. I didn't connect the fan at this point because it hadn't arrived yet. The connections on the rheostat are soldered, the switch uses female solderless terminals and I used a few crimp on connectors. I tried to keep things clean by using a few zip ties.


Click here for Steps 3-5

No comments:

Post a Comment